Kyle123 Posted September 23, 2017 Share Posted September 23, 2017 (edited) Hi, I am looking to buy a ton of toploaders. I am looking at some off brand ones, that seem very slightly concave in the middle. I have a few BCW and ultrapro toploaders that similarly have a bit of a curvature to them. Note the outside frame seems fine, it's just the thin middle bit that seems warped. Do you think these would be safe to use? Does anyone have any experience with long term storage in slightly warped toploaders? I mostly use them to store higher grade comics (VF or better), so stuff like not lying flat, small stress marks, etc. would be a concern. I would definitely use backing boards, which I imagine would help straighten them out a bit. If NOT safe to use, any suggestions where to get bulk toploaders cheap? Probably 300+ Thanks much! Edited September 23, 2017 by Kyle123 Link to comment Share on other sites More sharing options...
Bomber-Bob Posted September 23, 2017 Share Posted September 23, 2017 7 hours ago, Kyle123 said: Slightly concave ? Do not use these = they will warp the comics. I don't like top loaders for comics. Too easy to damage the book plus they are not sealed at the top. Link to comment Share on other sites More sharing options...