PGM Incredible Hulk 180

[Nimrodil]

Hi!

 

First post from a board-newbie from Sweden:-). What do you think of this one with all your knowledge and cgc-experience? I planning to send in a couple of issues during the fall and have think about pressing as well (not least with this one...). Hope the scans are ok? Thanks in advice!

 

 

[Topnotchman]

7.0

[Mystafo]

I'm going 6.0 with a chance at 7 after the usual work. But IMHO the creases at the spine and corners along with the lower edge wear and big back bend keep it out of VF territory.

[techvoodoo]

6.5

[Nimrodil]

I'm going 6.0 with a chance at 7 after the usual work. But IMHO the creases at the spine and corners along with the lower edge wear and big back bend keep it out of VF territory.

 

Ok, thanks- With "usual work" I guess you mean pressing etc?

[Thanos88]

6.0

[Captain_Pike]

7.0

[hcaworker-migration]

6.5 but could get to 7 or 7.5 with a good press and dry clean.

[marvelcollector]

5.5-6.0, leaning toward the lower grade as is...

[ROBTOTHEC]

6.5 IMHO

[KPR Comics]

6.0 here. Will not press to a VF.

[Chicago Boy]

nice book. Id say 7.0 on the high end and 6.0 on the low end

[Nimrodil]

6.0 here. Will not press to a VF.

 

Too much CB>?

 

Thanks everyone for your feedback by the way:-)

[KPR Comics]

Yeah, that's what I'm thinking.

Vertical creasing in black area along spine, coupled with LLHC front cover and LLHC back cover (most of which might press but I'm thinking enough CBC will remain).

And that's still assuming the impact creasing (URHC and LRHC back) pressed out.