Kramazeek Posted December 14, 2022 Share Posted December 14, 2022 (edited) Hi everyone! I’m relatively new to grading and CGC submissions and was hoping to gain some insight from this book. What I still have a hard time gauging is the manufacture damage on the corners. How would corners like this effect grade overall? What do you think an overall grade may be? Thanks and glad to be on the forum. Edited December 14, 2022 by Kramazeek Link to comment Share on other sites More sharing options...
Kramazeek Posted December 14, 2022 Author Share Posted December 14, 2022 On 12/14/2022 at 12:33 PM, AhsokaTano Jedi Apprentice said: Sometimes you can get micro tears on the edge of the spine from the manufacturing process which I don't believe really effect the grade ....this appears to be something a little more sinister. It looks like there is some edge wear from rubbing or something which at first glace would appear to be enough that it would effect the grade. I'm not very much in the know about these matters but I'll say like a 9.2 I'm sure someone else will be able to give you a better explanation and a more accurate grade. I think you’re right on this. Most of the spine looks normal but near that white spot in the top left corner you see more wear starting about an inch away. Thanks much for the input! Link to comment Share on other sites More sharing options...
scburdet Posted December 15, 2022 Share Posted December 15, 2022 On 12/14/2022 at 2:33 PM, AhsokaTano Jedi Apprentice said: this appears to be something a little more sinister I tend to agree here. It looks like the bottom corner got bumped at some point along the way. That said, if you look at enough graded comics online, you can see a large range of grades for corners like this that don't look like manufacturing damage to my eye. I would expect CGC to have a heavier hand with a book this new though. Also with two corners, I think you wouldn't have much hope of anything higher than 9.2 Kramazeek 1 Link to comment Share on other sites More sharing options...
grendelbo Posted December 18, 2022 Share Posted December 18, 2022 9.0/9.2 Thanks for posting. Kramazeek 1 Link to comment Share on other sites More sharing options...