PGM Transformers #1 (did the top back cover fall in a blender?)

[cannonfodder]

Hi everyone. I just wanted your opinions on the top back cover. Is this a bad cutting job during manufacturing or did someone decide to try out their Ewert skills using a butter knife? Thanks.

 

 

[mdandy8]

Printing error/too much time in the .25 box

 

I've seen books with similar issues that were unbagged in a box and thumbed to death

[FFB]

The jagged top edge is common on Transformers #1.

[divad]

The jagged top edge is common on Transformers #1.

 

The copy I sold to skinnywhiteboy had the same defect . . .

 

CGC graded it a 9.6

 

I'm afraid that this copy has a few too many spine blemishes.

[Dad&Son-migration]

with the creasing at the bottom staple on the back and the spine ticks throughout I would say this copper would get a 7.5

[Dr_Neff]

Printing error/too much time in the .25 box

 

I've seen books with similar issues that were unbagged in a box and thumbed to death

 

I would suggest that it may have spent too many years in a capital city distribution long box along with the other unbagged 330 copies each box

 

I went throught 80,000 myself (CCD books) from the bajillion book fiasco. It took me a whole week. Maybe it was 250,000 but I only had like 10% of that deal the 4,000,000 book deal.

[cannonfodder]

with the creasing at the bottom staple on the back and the spine ticks throughout I would say this copper would get a 7.5

 

How about a 9.4?

 

[CAP Freak]

Wow Thats great... in your face Dad&Son ...Just kidding